Mount Balusters Without Drilling Into Wood Floors

If you are installing the metal balusters in the same location as the old wood balusters you need to check the size and depth of the existing holes.

Mount balusters without drilling into wood floors. Be careful not to over tighten your connector. Not so tight that it has to be beaten down on top of it but not loose either. So drill a test hole and check the size. The hole must also be deep enough to allow the baluster to slide up into it high enough to clear the tread cap or landing shoe before it is straightened out and dropped into the 5 8 hole.

If the bottom portion of the wood baluster does not want to come up try rotating it counter. Measure and cut your balusters 3 4 longer than the distance from the bottom of the handrail to the top of the base tread floor. We purposely drilled out a deeper hole in top to give us this extra room. The end of the baluster is rounded into a dowel.

Drill 1 4 inch to 1 2 inch into the tread floor. This kit works great for banisters but as far as i know there is nothing that will allow you to avoid drilling into a wall other than attaching a piece of wood to it but then you would have to drill the wood somehow or using a pressure mount gate. Wood balusters may be attached to the handrail and floor in a number of ways. This makes iron baluster installation clean easy and most importantly secure.

Square baluster installation tips. Round hole with base shoe by far the fastest and easiest method. This requires drilling a round hole and using a shoe to hide the left over gaps. Slide the baluster into the top handrail first and then drop it down into the hole in the floor tread.

First slide your baluster shoe onto the baluster. Hi so we did have to drill into the drywall. The following visual guide showcases 6 different methods of installing square balusters with and without shoes. Make sure everything lines up and the pattern is correct before adding glue.

Others are installed into a hole in the handrail and may have a wood dowel in the base which goes into the tread or floor. Metal balusters that are 1 2 inch square will require that you drill at least a 3 4 hole in the floor and handrail surface. Some balusters are simply toe nailed into place. Step 7 epoxy base shoes.

Use your best judgement as you should know the material you are installing into step 5 cutting iron balusters to size. Insert the included installation screw into the connector and using a drill attach the connector centered on the marked locations.